Motion Pro Cable Luber V3 Tool

I find the lube tool easy to use, not nearly as messy as other lubers. I have used on my JetSki cables but it will work for just about any cable. Great products.

I tried a chinesium v1 copy and was total trash. Yes, this one is pricy but it simply works. Zero frustration and fast, simple use is 100% worth it to me.

Works well except that the red tube from your cable lube can is a bit difficult to fit into the rubber grommet on the cable luber. The hole in the luber is a bit too small, however it works.It won't work for the throttle cables on a Yamaha T700, as there are pins on the throttle cables on the handlebar side that prevent the luber from sliding over the cable. It worked fine for my clutch cable.

I needed to lubricate the shift cable on my boat because it was working stiffly. I ordered this tool because I liked the way it seals on the sheath so that the lube is forced inside along the cable. It worked perfectly! I also did the throttle cable while I was at it. I highly recommend this tool for lubricating cables.

I've never owned a dirt bike or tools for one until recently. I had a sticky throttle so I decided to get this one. It's a trick little design that makes great use of the principles of collets.It took all of about 5 seconds to figure out how to use the tool and only mess that I had when I finished lubing my cables, was the excess that came out the other end. My cable luber did not leak once.My only concern is that I'm hosed if I lose the rubber collet. I would like to get extras.

Worked great for throttle. Control cable was very tight almost frozen and I was unable to get tool around it and sealed to inject lubricant.

This cable luber worked like a charm. I have an old 1985 Honda Elite CH250 that had a screaming speedo cable, and there’s a lot of plastic covering it making the cable not so easy to remove and lube the whole thing like on a motorcycle.The instructions were great, and included clear step by step pictures of how to assemble it on the cable. The hardest part was getting to the top end of the speedo cable (see picture) but once I got to it and got this on there, I just unhooked the lower end of the cable at the wheel and shot my white lithium grease spray into it. The inner speedo cable shot out of the sleeve like a foot from the pressure, and then I just kept spraying until the grease was coming out the other end. Slid the cable back in, hooked it back up, and it was good as new. Highly recommend this if you have a hard to access or hard to remove cable that needs lubed up!

My clutch had become a little stiff so I purchased the Motion Pro tool and some cable cleaner. Took just a few minutes to disconnect the clutch cable, attach this little beast, and shoot lubricant down from the lever end to the engine end of the cable. Should have wrapped a rag around the engine end as the cleaning fluid shoots out all over. Cleaned that up, lubed the clutch lever and the clutch arm connecting to the transmission, hooked the cable up, and set the free play. Much better! Will do this on an annual an annual baisis from now on to keep the clutch in good condition.

It helps to watch a tutorial first of this luber and when I did it there was no leak, no mess. Whole process under ten minutes including removing the cable end from the handle.

Excelente calidad muy práctico

レビューを参考に購入しました。価格は、高いですが、興味深いので、購入しました

seve bien y funciona tal cual

Fantastic cable Oiler. Makes it easy and fairly tidy to lube your bikes cable. I’m very pleased with it and would recommend it to others. Thanks.