2U Server Rack Depth Extender Kit, 4in, 130lb (RDA2U)

Handy 19" rack accessory.

Perfect for use with my StarTech 42U four post rack. I made the rack very deep (900mm) when I constructed it, which was fine for all but two devices (both from Dell). Using this adapter meant my Dell sliding rail would fit properly in the rack. This adapter kit is suitable for almost any 2U device and square-hole rack, and works to either increase or reduce the rack depth. If this is what you're looking for, this is the right adapter for the job.

Fitted my rack perfectly and does the job, if your rack mounted unit is heavy you might get a little twisting though

Brackets were stiff enough so equipment wobble didn't happen, despite being further back from the front rails. The brackets came with M5 screws and T-nuts however for the brackets themselves (not the standard M6) so don't get things mixed up with your original equipment.

In a rack with limited space, these got me out of a fix. A very cheap solution.

These are really handy in a limited space rack.

Nice and sturdy. There is an issue with the design begin in the Z shape and wider than the rail causes some interfearence. Would prefer a C shape with much tighter bends as I had to extend out of the front rather than back as it would push against the PDU and bend the rails inwards.

Little bit light weigh to support an amp, but it got me out of a fix when I found the rack was shallower than expected. Unless the item you are mounting is very light weigh I would recommend additional support and to use these just to stop movement back to front or side to side.

Using these brackets works both for extending a device out from the rack but also if you want to recess a device inside of the rack - for example a power strip. Pricy but work as advertised and I see no sag for my Switch and Router that I'm using these on.

奥行き35cmのサーバーラックを 奥行き66cmのラック機器の取り付けを探したら これに巡り会え取り付けできました。 面白いアイテムですね

Funktioniert einwandfrei. Perfekt wenn man bspw. Glasfaser patcht und der Abstand zur Tür zu gering ist und man sonst engere Biegeradien hätte. So werden die Geräte nach hinten versetzt und man hat vorne genug Platz. Einbau funktioniert am Besten in einen bereits leeren Schrank. Nachträglich in ein bestücktes Rack integrieren kann unter Umständen tricky sein.

These are perfect for open racks when you don't want the patch panel jumper cables to stick out in front of the rack. You simply recess the patch panel and if you have a switch that is rack mounted you can recess the switch as well. This means your connections are protected in high traffic areas. They are also nice in closed racks as well so that your wires don't get squashed by the closed glass door.

Je cherchais partout cet objet, super pratique afin de deporter mes racks