3 X SEIP SKRJ433 compatible remote control replacement transmitter, 433.92Mhz rolling code keyfob. 3 Pieces!!!

Description

Programming / Learning Instructions Method One: Stand inside your garage with an existing working keyfob and use it to open and close the door, then within five seconds press and hold the two buttons on the original mini keyfob simultaneously for five seconds (Note: if you have an 'oval midi' type keyfob, use the centre top & bottom buttons. If you have the early type midi keyfob use the upper two buttons) until the courtesy light starts flashing to indicate that the receiver has entered into programming mode. Now take the new keyfob and press the button that you wish to use to operate your door and hold for one second, your new handset should now operate your garage door, repeat as above for any additional new keyfobs. Method Two: If you have lost the original keyfob it will be necessary to release the fixing screw at the rear centre of the motor casing and open the hinged cover, locate the red pushbutton which is located on the main printed circuit panel and press this button for five seconds until the courtesy light starts flashing to indicate that the receiver has entered into programming mode. Take the new keyfob and press the button that you wish to use to operate your door and hold for one second, your new handset should now operate your garage door. SEIP Coding Instructions from the SEIP head unit https://www.youtube.com/watch?v=uEwMz3vfCag. If you want to increase the remote control reception range up to 150-200 meters, then you can connect this aerial: https://www..com/dp/B01MSRPVD2