Slide Out Cabinet Organizer - Pull-Out Sliding Kitchen Cabinet Storage Shelves and Organizer, 14”W x 21”D, Requires At Least a 15” Cabinet Opening, Heavy Duty Wire Frame, Chrome Finish

Ich kann nichts Negatives dazu sagen. Es hält sich ziemlich gut. Man sollte nur darauf achten, dass man es gut festschraubt, denn es könnte je nach Beschaffenheit des Bodens im Schrank und bei kurzen Schrauben schnell dazu kommen, dass es sich aus dem Boden reißt.

I am very please and surprised at the quality of this product. With a lot of options that were out there, this was in the price point and looked online like high quality. Again i will reaffirm the quality from the start is great. It feels heavy weight and solid tubing /framework. Not a thin, could easily bend overtime with use. And the install is a breeze. There is a template to lay in the "floor" of the cabinet and the directions are picture friendly. If the template fits in the cabinet without modifications, the unit will fit. I purchased the 14" and 22" wide as they were the max, I could fit based on the recommended fit that is shown in the product pictures. I pushed the 14 inch width based off my cabinet had less then the product pictured recommendations, but it fit with very minimal clearance. Some additional insight for install: 1. I used a 1/16" drill bit to pilot hole for the screws, then the screws (4) were easily secured in the wood without any damage. No need to over tighten, just tighten to secure it from moving any direction. 2. If you look closely at the included pictures you will see that the 22" shelf is set back a little more then the 14". This was to offset the frame of the cabinet. The 14" shelf I wrapped the template to the front edge of the trim in the 14" and the track sits ever so slightly on the lip (1/32" or so, so it is slightly unlevel) but I noticed that the shlef did not ram the back of the cabinet, so on the 22" template I used the themplate wrap to the inside of the frame. It still fits very easily. 3. The templates are true to size so if you have to trim the template width to fit in a tight cabinet, make sure the print fits cleanly in the trimmed width. If you have to cut into the printed frame work of the template, the railings/glides will not work. Also note the placement of the cabinet hinges if you are going for a tight fit, will they get in the way. Overall very please with this item, and will be getting another set for a larger base cabinet, now I have determined I "need" it for. May look at 2 units as it is a 30" cabinet. The 14" pull out has the mixer on it, so you can see how tight that one is. Shockingly enough I installed the 2nd shelf in under 20 minutes, that was from cleaning out the cabinet, unpacking, and taking the picture. Not saying look at me I am so quick, but sharing how simple it is and it is well worth the time and money. And planning it out makes it so worth the upgrade, best upgrade to my kitchen so far. Maybe I need new challenges in upgrades:)

Ottima qualità dei materiali e del meccanismo di scorrimento. Silenzioso. Consiglio l'acquisto ...soprattutto se scontato

Solide. Excellent système de rails. Facile à installer. Parfait pour votre 1er projet de construction. Vient avec un guide en carton. Il suffit de le glisser dans l'armoire et de perforer des trous aux endroits indiqués. Requiert une perceuse avec une *mèche* de ⅛ de po (une erreur de traduction indique d'utiliser un *embout*, mais c'est juste mal traduit) et un tournevis étoile. J'ai complété l'installation en 5 minutes... Attention à ne pas inverser les rails. Dernier point: On pourrait avoir le réflexe de se fier uniquement aux dimensions du produit. À ne pas faire. Le vendeur indique quel tiroir acheter en fonction des dimensions de notre armoire. Je recommande fortement de bien lire avant d'acheter!

Best solution ever for storing my heavy crockpot. No more struggling, no more back pain.