ANVISION 2-Pack DC 24V 40mm x 10mm Brushless Cooling Fan, Dual Ball Bearing, YDM4010B24

Je les ai achetés pour remplacer les ventilateurs de mon ender 3 v2. Ils sont arrivés rapidement dans une enveloppe à bulles. Ils sont très silencieux et comparables à un sunon que j'avais déjà acheté mais ce dernier est 2 fois plus cher. De plus ils sont en 24v donc rien à faire si ce n'est une soudure sur les câbles d'origine car ils sont livrés avec un câble de 10cm environ.

presi per sostituire quella presente di fronte all’estrusore della mia stampante 3d, funziona egregiamente, non è un mostro di silenziosità ma la omologa sostituta non era meglio. a 24 volt e con grande efficacia il rumore fa parte del pacchetto per una ventola così piccola

3D プリンターで使用。 DC-DC で電圧を低めにして使用、風量も十分で音も静かです。 DC-DC コンバーターも Amazon で購入。

Less noise, less vibration than the original, the wires indeed they are shorter than the original on Ender 3 V2, BUT … if if you are good at soldering and you have a fine tip on your iron, you can sold the old wires, from the whole harness going to the motherboard, directly on fan. Remove partially the sticker on fan and you will have access at two soldering points (two short wires ended with a conector are soldered already) . Remove those two wireas and in their place you will sold the wires from your machine. Be careful at polarity. Put back the sticker. Done. Fixit with the same screws from the old one and close the shrowd, then attach the tireups.

Better than the original fan which failed a couple of days after purchase (manufacturing fault). Same number of blades as the original (7) and noticeably quieter than it. Cables aren’t long enough for a straight swap by any means, but was able to easily solder the original printer wires to the new fan no problem at all by slightly peeling back the sticker from the motor centre (magnifying glass helps at the contact pads are very small). Working well, with a few 3D prints done already. Worth the extra couple of quid over the many other options out there, just for the ball bearings rather than sleeve.