Rainbird Maxi-Paw Wrench

The tool worked perfectly!

You NEED this wrench. At least if you are trying to work on it that type head.Why do I say this? I am not sure its possible to remove the sprinkler head from the housing without it. I know I was unable to do so on a septic sprinkler - which has been set into a concrete pad. I figured it would be simple enough to dig around under the concrete pad (Its about 18" across) and unscrew the entire fitting so i would have a nice new housing! So I started digging and realized its pure clay - the extra sticky variety. There was not a good way to tell where the pipe was which made digging more challenging. And each bit of clay removed required me to use something to scrape it off with.After about 15 minutes of this, I realized there had to be a better way as I was barely down to the level of where I needed to be - and now had to dig under the concrete which required a larger hole. So I went inside to see if there was a tool I had foolishly passed on - and their was. Read the complaints that it was overpriced (Probably true, but am willing to bet they don't sell many so its a cost effective thing) and I thought I would take a chance. A few days later it arrived - and I admit I was not impressed with the looks other than the nice plating. Surely something so insubstantial in appearance would make little little difference, or if it did so would require massive effort.I removed the sprinkler from the new housing in seconds. "Ok", I thought. "This is clean and easy to get to. The one in the yard will be more difficult". And I suppose it was as I had to kneel down to fit the wrench. But it came right out and the new one went in with so little effort that it made me want to scream. I controlled myself, though, and decided to write this review.This will fit both the water and septic sprinklers. Highly recommended - and it will make a nice trophy on the wall when not needed.

Quick arrival. Appears to be of good quality, so should last along time.

It is what it is.

Worked perfect on the sprinkler heads.

This little item was just what I needed for my sprinklerTrying to access then with out this was a pain.This devise made it easy.Glad I got it.

This does work but if the sprinkler installed at an angle the device doesn't work. Also if your sprinkler is old (which it should be if you need this) you might have problems getting debris out of the inside so that the wrench will fit. If you have clean sprinklers on flat ground, this will work fine.

Did not end up needing this, but it seemed like a well made tool.