Blind Hole Collet Bearing Puller Set,9 pcs 8-32mm Inner Bearing Extractor Kit with Slide Hammer Insert Bearing Removal Tool

The media could not be loaded. Worked great, one side popped right out after about 4 yanks, other side I had to heat for 2 minutes with a torch after I let some WD-40 sit. 7 yanks later and it slid right out. Great bang for your buck.

Budget friendly and will get the job done. Great product

This tool is roughly built and the opposite of refined.. Had some blind bearings that needed to be replaced on a mountain bike, shouldn't be too tough, definitely easier than working on an vehicle. Made sure to heat the aluminum bike frame up a bit to make it as easy as possible, tightened the tool down and made sure everything was secure. And nothing. Couldn't even get the bearing to budge and the threads of the tool immediately started stripping. Absolutely failed to even remove a single bearing. And the bearings weren't seized, without too much difficulty I was able to use a punch and carefully knock them out in the end. Should have listened to some of the other reviews on here. I've had lots of luck with "cheaper" tools, usually if you're careful and go slowly they work out. But this one was just a failure.

This kit is pretty good. It does the job.PROS: great price, a pretty good selection of sizes, case includedCONS: case is not as durable ask I'd like - pieces don't lock in super securely

I ordered this hammer works great just want I ordered

I didn’t have high hopes for this at the price point, but it pulled 5 bearings that had been in my spoke wheels for 17 years. They never slipped or deformed. I highly recommend!

I don't use the tool much, but I needed it to change out some really small bearings on my bike. I have already dinged it up, but it got the job done and saved me from taking it to a friend or shop. I used it for a rear link on a full suspension bicycle. I hate buying tools until they get the job done. This tool got the job done.

I bought this instead of a significantly more expensive set from park tools and I regret it. The machining on each extractor was poor so the extractors would not grab the back of the bearing and would just slip out when pulled. Additionally the extractors were all not properly heat treated so I am not sure they will last even one more use and the act of tightening chews up the center pin.