LEDAUT 2 Roll 2" x 50' Titanium Exhaust Heat Wrap Roll for Motorcycle Fiberglass Heat Shield Tape with Stainless Ties

Quality of it is very nice. I was easy to put on. The fits the pipes nice. The metal bands will keep it in place. For functionality of it is nice. It gives some heat protection for your leg. Worth the value I have a lot leftover.

Not easy to install, but effective!

Muy buenos si lo sabes usar Mojalo y yo lo usé a un motor

Good stuff. Used a lot of other brands. I’d buy again

This stuff is not the easiest to work with, but if you take your time it works well. Definitely get it wet, wear gloves, long pants, and a long sleeve shirt that you don't mind throwing away. Wrap it nice and tight while it's wet and it looks great.

Easy to handle with care and gloves! Looks good but most importantly hope this hold my off road days on my afric twin

I used this in the headers of my '67 Volvo 122s/Amazon. The engine heat was greatly reduced. It looks good and one roll was enough to cover the entire header but perhaps a small portion of the second roll would have made it better. I could see the headers glowing bright orange/red underneath the wrap so I know it's doing it's job and taking that heat perfectly. Make sure you start at the collector and move your way up to the manifold.

Wear rubber gloves and long sleeve work shirt and dust mask. Even after soaking in water fiber glass particles sluff off. When they get on your skin you will be itching for days. Not a good idea to breath in fiber glass dust. Adhesion depends on how tightly you can wrap the pipes. Trimmed stainless zip ties are like razor blades. You need to curl the cut end under itself

very good!

Great value