Posi-Tap taps 14-16 ga. Pack of 6. Posi Taps (Choose Your Gauge Size and Amount) (6, 14-16)

I've been an ASE Certified Master Automobile Technician for over 35 years and have used Posi products for 20 years. Throughout my career, circuit repair and accessory circuit tapping technologies have made massive leaps. Today there is no excuse to use primitive, unreliable, higher resistance, crimping butt connectors that expose the circuit to the weather and corrosion. Until Posi came along, the only acceptable and reliable manner to repair a circuit was to solder and heat shrink. Now we even have self-soldering and self-weatherproofing heat shrink connectors. But Posi-Taps are safe, easy to use, a huge time and money saver, reliable, and a fantastic solution for tapping circuits in a tight space without dismantling half the vehicle's interior and where cannot use a heat gun or soldering iron. For my peace of mind, I've done resistance and voltage drop tests across Posi-Tap repaired connections comparing the findings against soldered connections and found them in tolerance. I recommend the use of posi taps but always do a reality check. Look at the vehicle schematics and make sure you are tapping the correct circuit, verify the load capacity on that circuit, and make sure the feedback from your device won't interfere with the operation of the sensitive electronics in your vehicle. add up the current draw of all of the devices already on that circuit making sure the device you are tapping into that circuit won't overload it causing a fire or worse. The current draw specifications for your devices are in their manuals. For instance, in automotive use, at 12-15 Volts DC, a 10 feet long, 26 gauge or AWG copper wire can safely carry 1.8 amps. Also, the greater the length of the wire the higher the resistance of the circuit, lowering its amperage carrying capacity. Be aware, that even some car cell phone chargers draw 3 amps which would overload a 26 gauge wire. But when in doubt talk to a pro.

4/19/2025 : These are amazing! It simplified the installation of a backup camera in an ‘01 Corolla. They twisted on easily on the reverse /ground light wires in the back, it was very stress free. Screwing the camera wires in required a bit of patience, just making sure the wire was in properly as I screwed it in, but that was mostly because it’s such a tight space! I’m still in disbelief that these taps work! I will definitely use them for future installs, and I’m tempted to use the connects for the harness and head unit as well, because it will make it so much easier to replace head units. Highly recommend, especially for backup camera installs!

I used these as a non-destructive way to tie into the CANbus on my car. These allowed me to easily read the data with my own device and confirm that it works without damaging any important wiring. I have yet to make a permanent install with these (still working on this project) but I suspect I'll use them for the final install as well.I'm sure some people would say that it's improper or not ideal to use taps to tie into the CANbus, but 1. these are the cleanest taps you can get, 2. I'm not sure how much better a splice by hand would really be, electrically speaking, and 3. it works fine.

I made the mistake of getting some cheap no name knock offs and had to replace them Due to them cracking and becoming disconnected. It was a pain in the butt to diagnose and do the the same work twice. Get these and do it right.

worked as they should.

Much easier way to splice wires rather than cutting and soldering

Brought my CBR 600F4i back to life. Easy to work with.

Easy to use nice cuality they work really good and they made mi job faster they are worth the money