6 Way Pneumatic Manifold Air Distribution Block, G1/2 Supply Port, G1/4-Inch Output Port, Aluminum Alloy

The media could not be loaded. I probably way over engineered this manifold for my truck’s onboard air. I like having all the cutoffs. One to an air outlet on the front and back. One to my airbags, and one to my air horn

I use this with my air compressor to clean up the spaghetti of air lines around the compressor. No more worrying about lines melting on the motor.

Works as stated,looks fine,no issues.

This air distribution manifold fills my air needs for my shop. It works as it should and is of good quality as I've had no issues at all. All pros and no cons. My expectations were met.

Incredibly low quality product, threads are cut way too big and it's pretty much guaranteed the leak at 90% of the fittings. Obviously the quality control on this product is a joke based on the reviews being all over the place

After searching around I found this manifold it fits perfectly into an expedition essentials ARB bedside compressor kit this way I was able to use the manifold to feed several different systems. Tire air down and up system, feed for air tank, feed for airbags, feed for air horn, feed for air chuck. Feed for air gauge.

I found out after I purchased these nice guys, that their aluminum... and some parts in my system is copper. Which causes galvanic corrosion. So keep this in mind if you purchase these guys.I like these parts, nice.

Threads are iffy, needed to chase them with a bottoming tap. There are better options with a longer lead time. Edges are sharp and need easing. Haven't hooked it up yet, so whether it holds pressure is unknown.