JSPForce 8 Half-Mask Respirator - Medium (Mask only) (BHT003-0L5-000)

I originally bought this mask for 3D resin printing to deal with the toxic VOC gases it produces—and it works perfectly! It completely filtered out the VOCs, and I couldn’t smell a thing. I’ve also used it while cleaning with strong chemicals, and it gives me total peace of mind, knowing I’m protected from harmful fumes that could cause respiratory issues.The mask is incredibly comfortable to wear, even for long periods, and checking the seal is super easy—just press on the filters. Bonus points for how simple it is to replace the filters when needed. If you’re working with anything potentially harmful to your lungs, don’t think twice—go for this mask and prioritize your health!

I have tried several masks over the years but this is by far the best. There are 3 main reasons why this is a great mask. The all important seal against your face can be tested with the press to test filters. In my view this is absolutely critical and very reassuring. Secondly, the fit appears to be so good because of a small cut-out in the chin area. This small design feature gives a much better seal than anything I have tried before. Third it is easy to take apart and clean. As a former engineer I appreciate good design and this mask is brilliant and should save a lot of lung damage.

The best thing about this mask is that you can pull it apart and clean it thoroughly and it's completely adaptable - you can adjust it in such a way as to get a perfect fit for your individual face which is great. The filters are REALLY hard to get on and off - which is my only complaint. I'm scared that I will break the mask itself holding onto it tight enough to get the filters on and off!

Well it's a pandemic. I got this along with some goggles because I experienced the insanity of SARS in Beijing in the 2000s and decided I was taking absolutely no chances this time out. I have elderly relatives and It's just me so I've got to stay healthy myself incase I need to care for them at some point during all this.For the correct level of protection against COVID-19 you're going to want to use P3 filters. It'll protect you from the virus when it is aerosolized and attached to dust or water droplets hanging around in the environment. Remember there is no such thing as 100% so avoid all but the most necessary of contact. If used correctly with a good fit and airtight seal it'll see you well. It's very important to remember that once you have a good fit not to keep touching your mask as that's where the contaminants likely will be. When you get back be sure to take extreme care in the process of removing an decontaminating it after use. This can be achieved with disinfectant solution. I would also highly recommend if this is the route you're going down to get some goggles and gloves too. If you're going to do it, do it properly.I won't give a guide on putting it on as a written account won't do it justice. Google the product and go to the manufacturers fit guides youtube. I highly recommend doing this as there is a process for it and it's vital you see it and get it right.As a final note, stay the hell inside.

Purchased to replace my old size medium mask as the rubber on the back has split, has had juat over a year of heavy use so I can live with that. The size difference between the old and new however is massive, clearly not the same size! Poor quality control or have the sizes changed?! Not very helpful. Have now ordered a large, let's hope that fits better. Elastic stops being elastic after a while, however still works ok.

Good product at a good price. Quick delivery. I use this when wood-turning on my lathe, and cutting wood with my band saw. Comfortable to wear.

Thanks

the product is fine but when you order this mask just know that it comes with no filters. This was a set back for myself as i went by the product picture.