Cleaning Bottom Router Bits JESTUOUS 1/4 Inch Shank Diameter 1 Cutting Diameter 2 Flute Carbide Tipped Cutter Up Shear Flat Spoilboard Surfacing Planing Tool
Descripción
- Use on hand held and table mounted portable routers as well as CNC and other automatic routers.
- Bottom cleaning router bits often used for cutting and smoothing a variety of materials from wood, plywood, MDF and other wood composites, plastics, fiberglass, and solid surface etc.
- 2 flute, carbide tipped.
- Up-shear configuration improves chip removal, while the cutting-edge orientation produces a smooth surface.
- Overlapped carbide produces a smooth flat bottom cut,Will level the bottom of a dado cut on all popular wobble blades.
Cleaning Bottom Router Bits JESTUOUS 1/4 Inch Shank Diameter 1 Cutting Diameter 2 Flute Carbide Tipped Cutter Up Shear Flat Spoilboard Surfacing Planing Tool
Reseñas
C**S
Does the job
The shaft is short if using a 1/2 inch or thicker router sled.
J**R
Worked Extremely Well
Cut a very smooth, shelf free spoil board for my CNC machine.
O**O
Rabbeting backup
Probably most people will purchase this particular bit to use together a router jig to plan a big piece of wood. It will work well to do that, I suppose.Personally I use its half-inch cousin instead of expensive solution with specific bit and a set of ball bearings. That bit in my router table with its fence can replace those sets offered to do these same rabbeting. It works very well. It is safe. It is flexible.This particular bit is not used yet as purchased it a back up just in case I have problems with its bigger version but from the experience I had with the bigger version, I am sure it is also great: flexible for different applications and high quality.Recommended.
R**R
This router bit works for flattening boards
I bought the bottoming router bit for my DeWalt 611 router and I used it to flatten some rough slabs of maple , cherry and walnut. It worked so well that I bought another bit. I flatten about 72 sq ft of slab wood so far with no problems and still going strong.
A**R
Does a fantastic job!
This bit is a champ and cuts perfect. I know typically it less safe to rout any depth greater than 1/8 of an inch at a time, especially with a 1/4 inch shank bit, but this guy was routing hard maple at 1/4 inch and I had literally NO resistance.Will buy again if needed.
D**Y
Quick delivery, works great! Smooth finish.
Smoothing power saw cuts on a large mantel. Not complete finish, but close as possible without actual sanding. Looking forward to using on some oak and walnut cookies I have been drying for awhile. 4 stars because this is the first time using one of these bits.
J**D
Nice little bit
I used this for surfacing end grain cutting boards. It seems to be tearing a bit now, but it worked great for several boards before I tried using it with some Ipe. That was probably a mistake since Ipe is far harder than most hardwoods.
A**Y
Nice bit
Seems like a good little bit. I’ve used it for milling a handful of walnut slabs. Seems to be sharp still.
Preguntas comunes
Trustpilot
Hace 1 mes
Hace 1 día
