Taccom Ruger PC Carbine Rear Sight Replacement Scope Rail

This rail fits the PC Carbine, just like as it was designed. The only thing about this is it is not necessarily made for mounts that have two cross bolts and the center rib. Because of the location of the bolts to attach it to the rifle barrel, there are not three consecutive slots. I have a Trijicon MRO and it needs three slots. You can mount a device with one of the cross bolts hanging off either end. The end of the rail is so close to the bolt that it doesn't really cause a problem, it tightens just fine but just looks a little funky. I'm keeping it and it works, but thought I'd pass it along.

this allows an aiming device to be mounted on the barrel. Being a takedown model the scope stays on the barrel instead of stock supposedly keeping the scope on aim better after taking it apart

Doesn't work with PC carbine models with M lok rail. Longer screws needed. Original screws are too short. Doesn't come with any screws.

I have an hand guard from Midwest industries and there is an interference fit, The opening for sight is problem the base of rail is too wide. Looking for solutions before I try grinding it may only need a spacer under the rail to raise.

Fits perfectly, as if it was made for my Ruger PC carbine :) I can see the red dot much better when mounted on the barrel.

Perfect fit!

Easy to install and puts red dot sight alot lower then top of the receiver and never lose zero when taking down.

good product but no free shipping(why i didn't give 5 stars}