Spurtar50A 6 AWG Battery Quick Connect/Disconnect (2 Pack) Wire Harness Plug, 12-36V Quick Connect Jumper Cables Battery Terminal for Car ATV Lifts Motors Trailer Towing Winch – Gray

I wanted to mount a 12V 1/0ga pigtail for my 9000lb trailer winch at the back of my SuperDuty.Some say these are loose and keep coming out of the connector; if you install each cable until you hear a "click", they won't come out. Make sure to melt solder in the connector per instructionsIt is a nice, tight fit even when connected. No sparks, arcing or cables getting hot.

Used for battery connectors, good quality

No instructions and not entirely obvious at first glance. Also you can't connect the two halves until everything is installed. Once the pins are on the wires and you figure out how they go in everything goes together just how you would expect.

Nice price!

Works great. Will add that I have 4ga welding cables on my connectors. Fit great.

I did a search for "trolling motor quick disconnect" and came up with a bunch a things that would have worked, but weren't quite what I was looking for (these things!). A few days later I was searching for something else and these showed up in the "you might be interested in...:" block down below. I ordered 2 sets, as I was unsure how they would hook up, since I might want to move my trolling motor from front to back, etc. so I wanted to have both bow and stern covered. These things are exactly what I needed. I did not crimp them since I don't have a proper crimper and didn't want to just smash them in a vise. Another guy mentioned soldering the wire in with a propane torch (which I do have) so I went with that. I was done in less than 5 minutes, and some of that time was monkeying with other things. I just heated the connector in a vise, melted solder into the cup until almost full, then heated it again to make sure the solder was molten, and stuck the (10 ga.) wire in, held it steady until the solder solidified. Shove them into the grey connector, done! They click together solidly, and even have covers for when they are not in use. very happy with this purchase.

Easy to set up

This will work great as a secondary battery disconnect for my solar system. I already have a switch, but I wanted a 2nd method to completely physically disconnect the battery from the system.

Used to connect 12 volts to my trailer from my vehicle. Still working well.

Very easy to fit, clicks in solidly as discribed, good quality connectors and easy to install!!

Se ve de calidad

Top Produkt. Macht was es soll und hält!Einfaches Crimpen / Verlöten der KontakteMeine Empfehlung

Ben fatte.. Dotte di pratici ganci per lo sgancio rapido e tappi