3M4910 VHB Mounting Tape, Acrylic Foam, Permanent Bonding, Heavy Duty, Clear, 0.5 in x 5 yd, 1 Roll

It works as advertised. I had some dry erase markers that fell off of their magnetic inserts, and chip clips which also fell off of their magnetic inserts. The magnets are meant to keep everything on the fridge. I'd tried superglue to adhere the magnets back onto their respective plastic markers and clips, but that failed. I then tried this, and it's holding everything together well.

Worked great for reinstalling clear shower door trim that originally came with a similar tape backing. This tape was fresh, pliable, very clear and very sticky.

Vhb

I used this to hold a few small lights to see at night. The others are fine and didn't fall off but the one in the direct sun has fallen off twice. I think it heats up the glue to the point it fails. Now to find something stronger...

I am converting a closet into a recording booth and using 12 x 12 x 1 foam panels as sound proofing. One set of panels are "mushroom top" and the instructions recommended this product for applying the panels.For ease of use, this took a some time, yet once it was started it was no problem. In order to peel the red backing from the tape itself, using fingernails to peel didn't work. I actually had to find a YouTube video which recommended using the blade of a knife to dig into the red backing to peel away. This was dead on truth and worked. Once I got it started I would cut the excess red backing just enough were there was a tab to grab and peel for my next amount.The actual tape is pretty sticky and works well. A couple of panels I actually applied to the back of the foam and to the wall, and the tape holds up very well. For other pieces of foam I used tacky spray glue and put a backing on the foam, then applied this product to the backing and applied to wall. I found this to be a better technique and the product is holding the panels in place. So the adhesive works well!I have yet to try to remove from wall as I know that if I remove in the wrong manner it will damage the back of the foam on the pieces that does not have backing. This is why I gave 4 stars under this feature.This product has proved successful for the use I need and this amount has proved just enough for my needs. If I needed to reorder, I would use this again.Hope this helps!

Works well

I used this to attach some plastic door track slides for some terrarium glass doors and it worked great

I must have gotten a fake one. I used this to tape an acrylic panel in front of a display case onto acrylic hinges. So nothing that should have been stressful. It fell after a few weeks, and I had cleaned thr surfaces very well and left it to sit without stress for weeks before that. It fell off during a heatwave, but it was inside on an interior wall. I wish I knew how to make sure I could get the real stuff.