Ard Nano V3 with USB Cable by Easy Electronics

Excellent product, value for money fully working compact

The packaging and everything was nice but one of the pins was not soldered roperly which caused me a lot of problems. However, after fixing that, it was running smoothly so no internal problems. Thankyou for the experience.

This product is very good and work properly I have made a project using it and I won 2 price in school I will highly recommend u to buy this

There is an error in uploading code but after researching I think there is no fault of arduino In my laptop there is not ch340 driver and i install it and working nicely WHAT DID I DO 1) See the port model no. In device manager 2) Go to the crome and search (model no. Of your cable ) and driver like (___CH340 driver___) 3) Download it and install it 4) Go to arduino idle and select arduino broad, port , change processer to OLD BOOTLOADER and then select programmer 5) Enter code whatever you want and verify it and then download I HOPE NOW YOUR ARDUINO WORK PROERLY

Very Good Product

It was okay, and as price suggests, definitely a clone with CH chip, not FTDI. Sadly its power management was not so good, so it died when i applied 12v on Vin pin (PIN30), where Arduino Nano spec says it should handle this voltage just fine. Mounting pins are not soldered, and usb cable is the cheapest one, with 1m length, but it works just fine.

This is a Arduino nano clone thus available at cheaper price, I was just unable to load any sketch on this thing, tried numerous times never succeeded, I bought this one to do the Ambient light setup for my Gaming desk, I tried different Pc's to load the sketch, all sorts of drivers, different usb cables, every troubleshooting videos on youtube, at the end I had to give up. Would recommend spending more and getting the original Arduino board. These clones sometime work sometime they don't, I did see multiple videos on YouTube using these clones, but i was not able to get this work.

1. A generic version, China made, generic copy of arduino nano. 2. Came sealed and with usb cable. 3. Pins were soldered 4. Serial connection/interconnection pins are not marked. 5. You have to install CH340 driver to connect with comport. (Driver is available on internet). 6. For this generic nano board, you have to choose (old bootloader) for uploading the code. It works fine, no problem to buy, but price is higher for a generic copy china made product. But what can one do, it is a fact that no businessman will do a business for loss. 🤑😇 It is also a fact that we have become lazy and impatient. 😴😴 So nothing comes cheap through e-commerce 😅😅.