LED Driver 200 Watts 24V DC Low Voltage Transformer， Waterproof IP67 LED Power Supply, Adapter with 3-Prong Plug 3.3 Feet Cable for Any 24V DC led Lights, Computer Project, Outdoor Light

It’s still a switching power supply. Some sensitive electronics will need a good low pass filter to clean it up. Better than those black bricks with noisy fans. I’d suggest you get one bigger than you need. 100 watt load, then get a 200 watt unit. Should last forever.

Used to power 16.4ft of Joylit 90w LED strip lighting with an RGBzone 8KHz PWM dimmer. Zero visible flicker, and zero flicker or even artifacts at 240fps slow motion video (mild stripes visible at low brightness but that's a dimmer related occurrence). After going down a rabbit hole of LEDs, electricity, PWM, and getting rid of LED flicker, I found myself looking for quality drivers that provided clean and steady DC power for my LEDs. The quality parts advertised and low ripple gave me confidence to try it, and while the more I learn now that it's not THAT terribly hard to provide said clean power, I'm still happy. The white insulation on the cables is tough and difficult to strip but that's a mild gripe. Overall quality product, gets mildly warm in use and gives clean power.

Voltage out was 23.5 and it’s loaded to 7.3 amps as measured on my Fluke multi-meter. So far so good. I’ll update this review if I experience issues.

This driver was way to big to be hidden behind the crown moulding even though we had a bigger crown moulding

This product does the job perfectly. However there is no instruction, and labels on the driver are misleading. You get 2 sets of 1 black and 1 red wire. One set is labeled positive, one set is labeled negative. It makes you believe that you can put together black and red but obviously you don’t want to do that. Long story short, at the end of the day, just disregard the labels and go with what makes sense: red is positive, black is negative.