Easy-Install RV Roof Vent Cover Replacement 14 x 14 - Specially Designed for Ventline (Prior to 2008) & Elixir (Starting from 1994) - UV-Resistant and Durable Vent Lid - 2 Pack

I like the fact that I didn't have to deal with a tiny baggie of micro-screws and nuts (not to mention the minuscule silicone washers, which happen to be as clear as the baggie and sticky as monkey snot) with these clumsy mitts of mine. Bravo to the riveted pre-assembly crew!

I have two vents in my LQ horse trailer, one vent was crumbling (over 10 years old, so not surprising!), but since they came in pairs anyway, I replaced them both. Easy to install on the roof, though I had to do some finagling because I couldn't get to the crank to take it off from inside the trailer, so I had to detach it from the roof side (screw is underneath the crossbar). Look great, much brighter in here now! Great value.

Our Coleman camper is five years old and the gray OEM Heng lid failed due to UV degradation. Like disintegrated into small pieces. Pretty amazing. It takes longer to figure out how to install this replacement than to actually replace it. Good instructions, good value.

These didn't fit exactly right to replace the ones that were up there already, so I had to do a little modification to the hinge but it is on, it is well sealed, no leaking. It's already rained and I am very happy with this product.

Great value for the money

This is a replacement vent on a 2014 sun seeker; to install this I had to remove old cover; from inside rv remove trim piece;remove screen and housing which are one piece; I had to remove screws to take off and also crank handle and 2 addl screws which allowed the metal housing ,piece that attaches to vent which raises/lowers vent, to fall inside giving you enough distance to reinstall the new vent. I slide the new vent on the roof hinge and from the inside of the rv I raised the vent by hand and inserted the metal crank housing back and inserted the metal section to meet with the hinge that raises/lowers the vent. This is the piece that has a round flat metal piece that fits in a track that allows the vent to go up/down when you turn the handle. Once this was inserted I made sure the vent went up/down with no issues. Reinstalled all screws. I will reevaluate my review once it rains to make sure no leaks. I did place a new strip of seal replacement gasket along the vent housing.

Haven't installed yet but exactly what replacing

Bought these to replace brittle vent covers on my 2017 Kodiak Express 253RBSL. They are perfect replacements. Reasonably easy to install. Tubular hinge slides right on. I highly recommend.