DPM Tapes - Bike Frame Protection Tape, Self-Adhesive, Clear Varnish Film for Mountain Bike, eBike | Prevents Scratches, Stone Chips, Gravel Damage - 2 in x 9.8 ft

Awesome.

I wanted something beefy thick to avoid the paint burn from frame bags straps vibrating and sanding through the finish when full of wet grit. I also wanted lean/rack protection as well as stone chip block. Fairly confident it will do that as long as the adhesive doesn't do what the other review said in the heat. Even so, at $25 and a few hours of detailed application for fairly attractive protection is reasonable.Nice and thick, easy to trim. Super clear, wet gloss look. With care to first tack lightly along the center, smoothing outward, trapping any bubbles can be avoided. Do NOT stretch while applying. It stresses in weird ways and will pucker. It does not like to be peeled and applied for do-overs. That causes stretches and puckers. Only if the first tiny portion gets mis-tacked can that be done without incident.On a 52cm All City Cosmic Stallion, the roll covered the outer faces of the fork, down tube, and rear stays. The scraps were just enough for the head tube around the head badge and a few odd small shapes on the rear dropouts. That left the seat tube and top tube completely uncovered. I have LaminX coming for those areas.The full width was good for the outside of the wide carbon fork and each side of the down tube. It did ok over the diamond braze-on reinforcements of the bottle cage bolts. I carefully trimmed out the bit covering the holes and replaced the bolts, taking care not to tighten them to the film making a twirl-pucker.I chose to slice lengthwise using half-width strips for the narrower seat and chain stays. Smaller scrap pieces kinda puckered around the tapered head tube. I'll redo those with the LaminX since its an easier, thinner, moveable, wet application.One quality note: the way the roll is factory cut to width in some sections leaves a bit of a wavy edge that will not smooth out. My roll maybe was cut with a dull knife along one factory edge, leaving a lot of adhesive boogers to rub away with my thumb for a clean look. Using cloth for that left highly visible colored cloth lint in the adhesive at the edge. The finger was best.When handling, do NOT touch the adhesive side with fingers. Prints show heavily and prevent adhesion at that spot.I'll see how it holds up to decide whether to repeat this purchase or choose a different type of film for my Crust Evasion.

El producto es bueno y realmente protege el marco de la bicicleta, el único detalle es que la cantidad de cinta es escasa

This product is not ideal for frame protection. It is very clear but the adhesive turn to gelly when warm and worse when hot.

I tried to roll it out while applying ( I have used another manf product before so I know how to apply it) but it would not roll all the wrinkles/air out

This tape has adhesive on both sides which wasn't specified in the description. It is also quite thick.