ATPWONZ 10M/32.8ft Air Compressor Tubing Polyurethane PU Air Pipe Set Air Hose Pipe Tube Kit 8mm OD x 5mm ID with 8 Connector Kits

Everything included in the set is as described, it all arrived packed into a pair of sealed plastic pouches. One slight negative with the packing is that the connectors are just left to rattle around inside the big bag with the coiled up hose but it didn’t cause any harm.There are two things I wish they’d added to the set, and the first is a simple tube cutter for clean and square hose cutting, and the second is a small length of PTFE tape for the threaded connectors. Adding both of those would pretty much turn this into a foolproof kit that would be applicable for a huge range of projects. It’s not a dealbreaker at all but it would be an easy way to set it apart from the competition and save people having to grab them separately.The included hose is just a typical single material hose with a good amount of flex and durability, it has no reinforcements or braiding. So it’s not going to be suitable for huge air pressures or really rough environments, but if you just want a dedicated run for a few tools or projects in a workshop or garage etc it’ll work well. The dimensions of the hose are spot on and it's a tight fit for the metal grippers and the sealing o-rings inside the push-fit connectors.All the connectors in the set work as expected and provide a robust and reliable connection that can be very quickly attached and detached as needed. There are a few things to be aware of if you haven’t used this style of connector before. The first is that the tubing needs to be cut at a clean 90-degree angle and fully seated into the connector to get the best results. The second is what the other reviewer has mentioned, which is the fact that the threaded part of the brass connectors don’t have an o-ring and will require some plumbers tape to seal properly.I’m not sure if I'd want to run any of the connectors or this particular tubing at or near the red-line which is claimed to be 145 PSI, but most tools are well below that and a 5mm ID tube should be fine for the CFM requirements of most DIY grade tools. It’ll vary widely from setup to setup but unless you’re going in far higher pressures and bigger tools this kit should be able to keep up for most home shops and applications.There isn’t much to fault at £18.99 as you’d probably pay close to a pound for each of the various connectors and around £1-2 per metre of tube from a dedicated pneumatics store. It's great to get most of what you need in a single purchase on short notice for a reasonable cost.Happy to recommend.

Includes 8mm tube fittings with 1/8", 1/4", 3/8" and 1/2" tapered threads (two of each size). Note these are not G fittings and do not have a sealing ring. All thread to tube adapters have a 6mm hex for tightening apart from the 1/8" which is 5mm.Also included are tube to tube adapters, two each of elbow, straight, T and Y.The fittings are serviceable in combination with the line by which I mean is flexible PU pipe, probably good for 10bar but I probably won't trust it above 8.