Suitable For 5050 Circular Saw Replacement Carbon Brush, Holder Spring Set of 2 2610993156

Easy installation and worked great. Fits in a Skilsaw 5250.

My Skil 5275-05 saw had burnt through its brushes and the white plastic brush carriers. I tried this set as exact replacements seem impossible to locate or are overpriced. These drop-in fit, but a spacer is needed to hold them in place. I used 2 pieces of thick rubber fuel line to hold these brushes in place. Works like a champ!

Quick arrival and fit perfectly. Much cheaper than buying from Lowes

The original brushes died in a very short time. I hope this set lasts longer. When you go to change them look at the base where they go. The original set got so hot they left material behind that had to be removed to allow the new set to seat properly. The quick change cartridge runs the cost up and melts leaving debris behind which takes time to remove. Higher cost bad design. To be fair about the same time this saw needed service I had to use my cheap import and the brushes went on it. I pulled them out cleaned them and stretched the springs and put it back together. Runs like new. I paid extra for a American made Skill saw and its nice to look at and probably better made in some ways but the brush system is a issue. Designed to fail and sell overpriced parts.

Take out 2 screws replace brushes; replace the 2 screws you took out and you are back in business. Very easy simple fix. New brushes worked like charm.

i replaced the brushes in my saw they fit fine .looked similar my where white .for some reason one of them just burned up

I have the Skil 5051. Took the chance of fit based on customer reviews and purchased the brushes. Took the two torques screws out and cap off the end of the saw. Pulled the old ones out. The new ones fit in there perfectly. Put the cap and screws back on and 10 minutes start to finish. "I'm in business ". Great purchase.

The brushes in my Skil 5250 still had plenty of brush material. However, they had gotten very hot and the springs lost their "springyness". This was evidenced by the uneven spring coil spacing. So, the brush assembly was toast. I cleaned the copper contacts on the armature with fine sandpaper. Cleaned the spaces in between the contacts with a small screwdriver. I put these brushes in and all works fine again.

I received one pair 3 Oct. 2020, and installed but both were burned as attached first picture, then the seller resent me one pair after I reported its problem.I installed them carefully again , and check their position and rotated manually for judging smoothness , now my circular saw runs well. It proved my first installation might be not fitted well,.Thanks to the seller

Item arrived quickly and works well.

Received as expected.

very good

As I expected