CNC Tips and Techniques: A Reader for Programmers (Volume 1)

This has quite a few good explanations of some of the more obscure G codes, especially relating to offsets and canned cycles. Being a reprint of magazine articles makes it somewhat disorganized, though there is a topic oriented table of contents. There is also some confusion about the various codes and formats used by various machines over the years. I found penty of good information to justify the price but had to read most of it twice to absorb everything. A bigger book or fewer topics would have made the whole thing more manageable.

there are a lot of usefull tidbits

fairly useful and informative

Amazing book!

No illustrations for kindle. Not much useful tips. Not organized well on topics. Same info repeated from Peter smid's other books

Very helpful. Can't go wrong with Peter Smid

Good info.

Good book

Did not think this book was of much use, no real good advice for some one starting out at CNC programming.

VERY POOR PAPER AND PRINTING QUALITY