Package with Flow detector switch + Flow sensor for 1/2" inch pipe (DN15) + TRIAC + 12V power supply

Simple solution that allows you to control an alternating current load from the detection of a certain flow of liquid. Ideal for starting a Motor, a pumping system, a heater, an alarm, etc.

*JDH FLOWSWITCH Features:
- Isolated output by optoTRIAC optocoupler suitable for 120VAC or 220VAC loads
- Power supply from 9 to 24 VDC
- Universal connector compatible for Hall effect flow sensors

*Characteristics of the TRIAC TCG35C60
- Maximum current IT (AV) 35A
- High surge tolerance capacity up to 330A
- Isolated mounting (AC2500V) with holes for fixing
- Lug terminals for easy and universal connectivity

* FLOW SENSOR Features:
- Water pressure: 2.0MPa maximum
- Operating Voltage 5-18V DC (Red Wire)
- Mechanical resistance = 30 N / any direction
- Operating temperature: 1 to 80°C

The sensor must be installed in a vertical pipe section, so that the flow rises through it, from the bottom to the top, that is, the flow "rises" from the bottom to the top through the sensor covering its cross-sectional area totally. The flow must be free of air bubbles or solids that could obstruct the rotation of the internal turbine.

The important consideration is that in its installation the transversal section of pipe is full while liquid is flowing, with the liquid completely covering the cross-sectional area of the sensor. For this reason it is preferred that the sensor be installed in a vertical section of pipe. Otherwise, there is a risk that the turbine will rotate even with any trickle of water running, giving incorrect measurements.

JDH Flow Switch for Adjustable Liquid Flow Detection + Sensor + TRIAC TG35C60 for AC Load Control (G1/2" inch Pipe) (G1/2")

Descripción

Preguntas comunes