VICPRICME Epoxy Putty Stick, 120 g 2 Part epoxy Quick Repair Adhesive, Hard and Fast Repair for Pools, heaters, Bonds to Metal, Plastic, Wood, Glass, Ceramic Crack Filler, Heat and Waterproof

This metal glue is incredibly strong and easy to use! The 2-part AB epoxy mixes smoothly and sets quickly, creating a solid bond that feels just like welding. I used it to repair a broken metal part, and it held perfectly — no movement at all once cured. What impressed me most is the durability. It works on cast metal, steel, and even in outdoor conditions. After a full cure, the bond is rock solid and completely waterproof, which makes it perfect for marine use as well. Another big plus: I couldn’t find this product in any local stores — not at Home Depot, Lowe’s, or anywhere else. Amazon was the only place I could get it, and I’m glad I did because it worked perfectly.

Perfect for repairing an office chair that I have not been able to repair with any other similar products that are available on the market. The finished strength and smooth finish are outstanding but the key to this product is that you must allow it to fully dry and cure before using what you have repaired. In my case I allowed no less than 48 hours of warm drying .

Great product. Easy to use, not messy, doesn't smell. Put together an old candelabra. Worked like a dream.

Ok job.

Great product no issues at all I will order again

Used it to glue 16 gauge steel together and after 24 hrs. it adhered beautifully. Easy to mix and apply.

I used the glue today on an automotive trim repair. I expect that the glue will perform well as it is similar to others I have used. The thing to let any prospective buyers know is the arrangement of the tube dispensing system. It uses the now standard two side by side tubes with a twist off cap and a dispenser plunger. The strange thing is that the plunger is not part of the assembly but is separately inserted to push out the material. Since it is not physically connected to the internal dispenser when you have the amount you want out there is no way to stop the material from coming out until the pressure lessens. So you either get too much which can get everywhere or a mess to clean up on the end of the nozzle. Luckily lacquer thinner dissolves the wet glue so it is possible to save most of it. Be aware of this before you buy. I won’t reorder just because of this issue.

Ok so u only get one plunger it’s flimsy n difficult to use. Ones mixed it’s just like any other and it does not like a lot of heat I applied to a muffler it turned black n chipped away