GETINLIGHT Dimmable Hardwired Only 3 Color Under Cabinet LED Lights, 24-inch, Soft White(3000K), Bright White(4000K), Daylight White(5000K), Matte White Finished, ETL Listed, IN-0201-13-WH-345K

Awesome light. It was easy to install and work great so far. I appreciate the light brightness and color options.

The 3 color one is $4 more, but worth it. Not only can you change the color temperature with a slide switch between 3000K, 4000K, & 5000K, but the on-off switch can go to either full brightness or about half brightness (with no need for an external dimmer). The fixed color temperature models have only an on/off. No half brightness. See attached photo showing both The half brightness was about the same amount of light as our florescent fixtures that these replaced. The full brightness was much brighter, and maybe too bright. We plan to keep them on half brightness normally, and maybe switch one to full brightness if we need extra light for prep, etc. I installed 5 of these in our kitchen. The knockouts for the wiring are very small in diameter, but as it turns out they are exactly the same as the florescent fixtures that I replaced. There just isn't room for a full size hole. There is plenty of space for the wiring inside the unit. The cable clamp that comes with it is designed for a BX cable. The sheath of Romex will not fit through the hole. The sheath must end at the cable clamp. Most of my fixtures had two Romex wires as they were daisy chained. Both cables had their sheath end at the cable clamp, with the 6 wires going through the small hole. That fits, and it is how it was already done for the existing florescent lights. I just used the existing cable clamps, which are the same type as supplied. Installation took maybe 15-20 minutes per. So far they work great. I have not installed a wall dimmer. With the ability to go half brightness on the 3 color models I probably won't need to. Glad I bought the 3 color models.

Replaced our kitchen under counter fluorescent lights with these led lights. Once installed, the lighting is a very clean, bright white light which we think is perfect for kitchen counters. But the installation was extremely difficult. This is probably mainly due to the way our fluorescent lights were originally installed. They are mounted under the cabinets almost flush against the kitchen wall. So the wiring going into the lights is very short. Also each of our lights had two wires going into it (to connect to the other under counter lights) and it was really difficult to put both wires in the new lights. The knockout hole is too small to really accommodate two 12 gauge wires. I couldn't bring them in different knockout holes because the original wires are too short. It took a long time to finally get the wires into the new fixture and then secure the light to the cabinet. All of this is compounded by the fact that you're working upside down in a very cramped space under the counter. If you have a longer length of wire to work with coming from your wall, the installation will be much, much easier. I gave this a four rating because the lights are really nice and lighten up the kitchen counters significantly. Just be prepared for a potentially difficult install, depending on your existing wiring. Bought both the 12 and 18 inch size. This review applies to both.

I have several under cabinet fluorescent lights in my kitchen I want to replace, so I tried one of these, the 18" version with 3 color temperature selections. It's perfect. Fits in the space of the existing fixture, easy to install, and the low/high power output switch is very helpful. I agree with another reviewer that on low output it basically matches the former fluorescent light and is bright enough for most uses. I found the 4k color temperature (middle position) the best to my eyes. And it's ETL listed which was important to me, and the quality seems like your typical "contractor grade" fixture. In my case it's out of sight, so it doesn't matter that it's all plastic. I plan to buy more as my other fluorescents give up the ghost.

I tried a few different under cabinet lights and these were by far the best. - they include a two-way switch that lets you choose low or normal brightness. - they have a good amount of space for wiring. I live in an older home and have some fun wiring setups behind the cabinets, including some heavy gauge romex coming from the microwave. I was able to pigtail everything and fit it all in the space provided (which was not the case with other brands). - Easy to install - The color temperature is easy on the eyes and compliments the room nicely - Overall, these are the best quality and design that I found on here.

Beautiful, bright, under cabinet, kitchen counter light. My old florescent fixture is dim by comparison. The installation video at the top of this page made it easy to set the light up as a simple, stand-alone, corded light fixture that plugs into a wall socket. I could not have done it without the video, but the video was excellent! The light came with no instructions (of if it did, I lost them). Without the video, I would not have figured out which screws to use to open up the light, or find the installation screws, wire nuts, or adaptors, or which hole to knock out. It was not at all difficult, but it needed the instructional video. The video showed me exactly how to set the light up as a corded, plug-in fixture. There was room inside the light to add some extra cord length in case I want to eventually use the light elsewhere. The video recommends adding a simple loop to the cord (inside the fixture) to prevent the cord from pulling out. It can be a very loose, single loop knot, which can be worked along the cord to adjust its length after the fact. So I started a little longer, and then shortened the amount of cord that would extend outside of the fixture, in order to neaten the under-counter wiring. Instead of a wire staple like the instructor used, I prefer a cup hook, so that it is easy to remove or replace the cord if I ever have the need to do so.

Looks good and works well with good instructions.

The light was easy to install. Two pilot holes in the cabinet made the screws grab right away as they aren't the sharpest and my cabinets are hardwood. The screws thread into the plastic holes which can make the screws tighten before the housing is flush. I slightly enlarged the holes so the screws free spun in the housing. It tightened up flush very nicely. Wiring was easy. I chose to feed the wires through the back access plate and hook them up after mounting which worked well. I did have to strip some outer shielding off the feed wire as the hole in the panel is quite small. I added a star washer to the nut which doesn't tighten that well without one. The light is good quality and illuminates our sink area very nicely. Overall it is a nice simple light and it looks good. This is a great replacement for a flickering or buzzing fluorescent light.

Easy to install and works reliably. Perfect illumination for above the kitchen sink.

I would have given this product a 5-star rating, because it is attractive, sturdy, well-made, very attractive and very bright with a nice daylight type of light. And the wiring and internal electrical fixture is very nice and good quality. BUT........the instruction which come with the product are HORRIBLE. Basic things are not explained, like: - how to take off the cover plate are not described properly (it is hinged on one side only, so if you try to pry it off on the wrong side, you will damage it), - the steps for wiring are not in chronologic order, and essentially you need a basic understanding of electrical connections to get the job done - the screws to attach the fixture to the ceiling do not go all the way through the hole and are very stiff and difficult to screw in, making attachment while holding it impossible. So you have to screw them in first without attaching it to "loosen up" the hole and prepare the attachment and THEN you can screw it into the cabinet or ceiling relatively easily. All of these things sound minor, but if the instructions were clear and correct, it would take under 30 minutes and with no frustration. That having been said, I am by far no electrician and I was able to install it in under an hour, but with a lot of "trial and error" for each step, which really should not have been necessary. So my recommendation is if you want a really nice-looking and very bright light for your kitchen, this is the one. But be prepared for some installation frustrations.

These lights are great easy to install the are good quality.

Pas si facile à trouver sur le marché, j'étais content de trouver ce type de branchement sur Amazon. J'ai bien aimé la qualité et la facilité d'installation. Une fois l'électricité coupée, ensuite il est assez simple de rejoindre les 3 couleurs et d'encastrer le tout. Grâce à la vidéo sur Amazon, je n'ai même pas eu besoin de la notice. En plus, cela donne un bel éclairage dans la cuisine !