Mini Heater for 3D Printer, 3D Printer Temperature Controller Heating Thermostat Temp Control for LCD DLP 3D Printers

Bought this heater to use on my Anycubic Mono 4 Ultra in the basement. I use several thick resins with high-temperature resistance and I really need to be in the 30-35C range to get reliable prints. This little unit is smaller than the Anycubic heater I have in another (larger) printer. I couldn’t fit the Anycubic heater in the Mono 4 Ultra printer, but this one fits with room to spare. Seems to be doing a good job keeping the temperature in range. Easy to set and use. I leave it running about all the time. Been going strong about 4 months now. I am buying an extra to keep for the day when a heater dies unexpectedly. Heaters in the cabinet work well, and this model is my current favorite.

kleines kompatkes Gerät was hilft die Temperatur in meien 3d-Drucker kasten stabil hält. Vorheizen des Kasten baucht lange wenns die Raumtemperatur sehr kalt ist.

I've been using this for a few weeks now and it works flawlessly. It does a great job of keeping the resin and internal print area warm. I've set it to 28°C and it has no problems maintaining this temperature for several hours at a time (longest print so far using this was about 9 hours 40 minutes) within the printer while outside the printer was getting down to 6°C at times. I did have to buy a lead with an Australian plug to fit into the converter, so I could plug in into the mains power, which cost about $12 from Jaycar, but was happy to do so to be able to use such an excellent little device. I would like to see an option where this could plug straight into the USB sockets in the Elegoo and Anycubic printers that have them for the air purifier, which I think are 24v. Having an air purifier on one side and this heater on the other would be great.

Funciona muy bien

This is my third purchase of this Youyoute Mini Heater. I use them in my three resin printers. I set the temperature to 30C and after about 30 to 45 minutes the resin is up to print temperature. Printing this warm helps a lot with getting good prints with very little print fails. I find it especially useful for heating a rubber like resin that I use because if cold it's like syrup and thick. Heating it to 30C makes it print perfectly.