JET JJ-6HHBT, 6-Inch Helical Head Benchtop Jointer, 115V (718600)

weight. this is luggable. I will remove the fence to transport it.Not too loud. Dust collection is good. Powerfull.The Castings:ground flat, good finish, any uneveniness i could measure is probably because I haven't cleaned the surface.The fence is heavy. The casting is webbed in the back, if it wasn't it would take two men to move it.The fence stays square enough. I adjusted the stop with a square, square to the table. Then holding the fence against the stop tighten the clamp. There is some slop in that, so hold it to the stop and tighten to prevent play.The tables are flat and coplanar to my eye.I ran four 3" x 5" x 3' Pecan posts through it in a few minutes. It did not bog down, and i was feeding them at not too slow of a pace.Good smooth finish, almost slick.the cutter head is Wonderful! no tearout. (except on one side of knot where it was acceptable)one tooth is leaving a .0005" ~ line. The cutters look fully seated and don't wiggle.it is a nice looking tool.the bed could be longer, but it is long enough.The dust bag does billow in the way of the outfield table a bit. The zipper blew open on the first cuts, but stayed closed thereafter.My bench will be finished !

It's good. But you will regret not buying the one with a bigger table.

The media could not be loaded.

It’s very convenient to have the helical head cutter with inserts, very precise, and easy to move from one place to other, the only inconvenient is the price. 😅

I’m very pleased. Most bench top jointers are aluminum or at least the fence is aluminum. And will not remain square. The Jet is all cast iron, flat and once adjusted to square, seems to stay that way. The helical cutter head is sharp and very quite. Makes a great smooth cut.