Quickun 304 Stainless Steel Pipe Fitting, 1/4" NPT x 1/4" NPT Male Malleable Cast Pipe 2" Length

Finish on them were not even close to resemble the picture.

Recomended

We put up a closet system that gives us more space in a walk-in closet. The system is such that the area between the shelving/hanging units is covered with these rubber pieces for aesthetic reasons more than anything else. However, probably because of the way we cut the units, the rods kind of split apart in 2 areas with one hanging beneath the next one, causing the hangers to slide. We measured the width and this was perfect to cover the area and give it some support. We taped over it with white tape so it matches the closet units and it's perfect.

I used this to mount a hand sprayer in a custom shower i built and it worked out great. Not quality material but did what I needed it to.

I put risers on my Spyder and love them, but if I had thought sooner, I wouldn't have cut off the old handlebar! It is a good place to add accessories. So, since that bar was gone, I had to thread into what was there and thread these pieces into that space to carry 'handlebar accessories'. These work well, I put one on each side and I am using them with handlebar mounted gadgets. They are solid, the right O.D., and I am hoping that the SS construction means that they won't rust because I run in the sun and rain.