RLRHOO 2 Pcs Non-Fading Car Door LED Logo Projector Welcome Lamp Door Light Puddle Lights Kit Compatible with Accessories W221 S Class 2008 2013 S500 S350 S63 S65 (S Class, W221 2006–2013)

I just installed these on our 2020 C Class coupe. I was so surprised how easy it was to swap over , it took less than 5 min to change over both lights. The image is crisp and bright, great value and a fraction of the cost at the dealership! super happy with them and highly recommend.

I bought two sets of these for all four doors on my 2013 Mercedes S550, and they are as simple to install as popping out the factory lights, plugging these in, and you're good to go. Now the bad thing, as another reviewer mentioned, at least one of the lights in each set of two comes with a defective logo with a dark spot that reflects in the middle of the logo. The second, and to be honest, unforgivable defect, is that the lenses are not aligned to reflect the logo straight on the floor without distortions. All four of my doors show the logo with lens distortion on the logo. Instead of reflecting a nice rounded logo on the floor when the door is opened at any angle, the logo will always look distorted despite the position of the door. These lights are made for specific cars, so correcting this from the factory should have been done, all it would have taken was to correct the position of the tiny lens, or the angle of the LED that lights it up. I know these are being marketed as non-fading, and that's great, but that is something that only time will tell, however, for everything else, they are no better than the much less expensive option being offered here on Amazon. I will keep mines since I already installed them, but in all honesty, I expected a better product, and this one failed to make me happy.

Fits just fine.

bright and clear projections, but a few flaws..1.) the plastic is not as shiny as original light, looks dull/cloudy. not a huge deal but it would help presentation.2.) light doesn't snap into place like it's supposed to, just fits snug in the cutout of the door. also not a huge deal but quite annoying.3.) when connecting new light to the plug in, it also does not snap into place like the original connection.. you just have to push it in there tight and be cautious putting it back in while hoping it doesn't come unplugged by some chance. maybe use precautionary strip of electrical tape before putting it in the door.