Everybot RS500 Robotic Spin Mop and Polisher

Highly recommend for hard floor. Easy to use. Very thoroughly clean and efficient. Can’t beat other products.

This Robotic is the perfect cleaner and smart enough.But the Spin holder is easy to broke and can not hold the mop part anymore, please let me know how to change and buy this part. Looking forward your reply.

Worked fine for a month or so and then one of the plastic disks broke that holds one of the cleaning pads. Their customer service is nonexistent. I finally found an email address but they told me they were located in Singapore. Eventually I was wrangle an email address from a distributor in the US from them. They offered to send the part for free. However, after a month I had to follow up again because they forgot to send it. After installing the new part (which appeared to be reinforced so perhaps they recognized this component as a week point) the new part promptly broke on the first trial. Luckily they had sent two parts (one for each cleaning pad) so I used the other. That one lasted about 5 minutes and then it broke.Also, the programming logic does not seem very robust like Roomba. This unit recognizes a flat wall but if there is small overhang such as a kitchen cabinet it repetitively spins in the exact same spot. At least Roomba will give up after a few cycles and go somewhere else. At least one spot in your kitchen will be spotless!

1. The fluid reservoir design is flawed. The do not have replacement wicks like the Bravas and other models. Rather the fluid wick is built into the reservoir. They go bad quickly and then fail to deliver fluid to the washing/scrubbing pad. If you have a dremel tool you can carefully cut a 3/4" hole into the fluid reservoir and use iRobot Braava Pro Clean Wicks, Replacement Wet Sponges like the ones in the link below. If you cut the hole too big you can always use a silicon seal or sealant to prevent leaks but use something that is NOT permanent because you are going to want to replace these Braava wicks regularly. Once I did that, mine works incredibly well.https://www.amazon.com/iRobot-Braava-Replacement-Sponges-Accessory/dp/B00DJMU5S8/2. I cannot find anywhere to purchase additional fluid reservoirs. I would like to have more than one fluid reservoir as backups just in case I break one of them. Since Elicto doesn't sell replacement fluid reservoirs I am going to drop one of the plastic ones off at a friends place who does fabrication and see if he can fabricate one out of aluminum with the 3/4" hole so that I can continue to use iRobot Braava Pro Clean Wicks, Replacement Wet Sponges.3. It seems the lithium ion battery goes bad in about 6 months.In summary, this is a great floor mopping/scrubbing robot. It is fast and strong, though that does mean it is going to be quite a bit louder than a lot of models. If Elicto re-engineered the fluid reservoir to use replaceable wicks like the iRobot Braava's then the problem would be much better.

This works in theory, but the water reservoirs do not dispense ANY water at all. They are still full even after 3 full hours of cleaning (with recharging in between). The only way to get it to work is to "rewet" the cleaning pads manually, which sort of defeats the purpose. I have tried to get a replacement with the Elicto store, but I was only offered to get new pads! which makes no sense, the pads work fine. Well, they do leave a dry spot in the middle, but I could live with that if the water was working correctly. I am past my return period, since I had hoped to get it fixed by the seller. I also bought the new version on the Indiegogo site, I may take my money back there.

Love this thing. This is my second one the first one was stolen. This dose the light cleaning on a day to day bases and makes the major cleaning easier.

It is good

I should have believed the previous feedback. The water dispensers are defective. Only 1 worked. It did not clean the floor and I returned it the next day. Thank goodness Amazon has a great return policy. I suggest looking for another product.