Lian Li LI PC-O11 Dynamic EVO Black ATX Full Tower Gaming Computer Case - O11DEX

This is a great case for a show build, and flexible if you have specific needs like I do. I wanted a display case for my custom-built ATX 4090 / 5800X3D, but I don't have room on my desk for a typical right-side case. I needed a left build or something similar. I also needed something that would fit on the desk in a reasonable way and that wasn't too big. I looked at the Thermaltake 500. Looked cool, but the dimensions were a little off for my space, interior design seemed questionable in some ways, was a bit worried about the thermals, and read some negative reviews. Also looked at the Segotep T1. Again, not fully confident in the case and the size was a little too big. Lian Li has a great reputation, the size of the 011 Dynamic EVO was right (the XL looks amazing but BIG), and the needed accessories were reeadily available. I decided to go for it. I'm quite pleased with the end result, the case has incredible build quality, and looks awesome, BUT it was not an easy build for what I did (reverse build with upright GPU). That said, it did come out essentially perfect. I used the black 011 Dynamic EVO in reverse. Case set up was not too bad. Everything went in fine, but getting the GPU positioned and attached properly was a challenge. If you're looking to do the upright GPU, be sure you get the updated bracket (https://www.amazon.com/dp/B0C1Z2WVYM?psc=1&ref=ppx_yo2ov_dt_b_product_details) and 600mm extension (https://www.amazon.com/dp/B09XJRHYCT?psc=1&ref=ppx_yo2ov_dt_b_product_details). I also used a 16Pin Right Angle Adapter for the GPU (https://www.amazon.com/dp/B0BWDVC44J?psc=1&ref=ppx_yo2ov_dt_b_product_details). Made the job easier and looks better. For fans I went with the AsiaHorse Matrix (https://www.amazon.com/dp/B08LQ9FKKJ?ref=ppx_yo2ov_dt_b_product_details&th=1) to add some side RGB and cut down on fan cables. Temps have been pretty good and equivalent to (if not below) the temps I was getting in the Corsair 4000D. Around 35c at idle and up to the 70s under load. Have the 3 bottom fans and rear fan on intake and the two AIO fans, plus 3 fans mounted behind the GPU set for exhaust. Cable mangement is good, everything fits including the hard drive cage. I did set the PSU on the bottom. Fixing the bottom bracket for that orientation in reverse was tough becuase the bracket doesnt have cut-outs for the screwdriver in that orientation. My GPU is an MSI Gaming X Trio and it fits fine, if snug. I did go with a 240 AIO because the 5800X3D runs cool and a longer AIO would be a tight fit with the GPU, but probably possible. All in all, I highly recommend this case but caution that it's not an easy build. If you want a really well-made case that's not enormous (like the 011 XL), especially one that can do a left-side build with an upright GPU, this is a great case. Go for it.

Computer have gone a long way! Haven't owned a Lian Li since the PC 60! Installing the GPU Upright kit is a nightmare if you already have everything installed. I suggest doing it before everything else, including installing the PSU afterwards. Cable management is all confined to the read center piece allowing you to conceal a web of messes. The only real co plaint with installing the upright GPU is this simply. The entire hole for the top cable management to hide others becomes fully occupied by a PCI-E Riser cable. Expect outstanding ambient air drops on your gpus backplate, don't install the panel that is used to mount addition ssds and the GPU upright, use that space for fans! I'm using the Artic P12 aRGBs mostly in this case. Besides for the radiator for my EVGA RTX 3080 XC3 Hybrid Water Cooler as seen hiding the tubing the front. I also installed mostly pressure dynamic fans because their cfm is rated above 40 and they're pushing air harder through all components and radiators throughout the case. I did notice a negative 10 degree celiua drop on my CPU loads! It's throttling between 35-40 standard, 50 C gaming on ultra with and performance boosts no oc. 70 c under stress testing. Great thermal dynamics with Artic products throughout the case. As for the GPU. Wow!!! 28 under no Boost locking, 30-40 gaming water cooled. Amazing case.

Not one complaint. Enough room for a beefy GPU and a 360mm AIO. With 6 intake and 4 exhaust fans, I haven't had an issue with cooling either.

Very flexible and configurable to your needs. Very good cooling with all the fan options if you use multiple fans for push pull cooling. Well made and looks great with some RGB fans. Takes a little time to decipher the instructions for some features on the first build but once you understand the design it's easy and even easier on the second one you build. I really like this case.

I now have three Lian Li cases (the first from 2015). And while they're not inexpensive, you get what you pay for: a high quality, attractive (imo) case with excellent air flow. Each subsequent design/model improves on the past. The Evo certainly does. It is a smaller case, between the Mini and Dynamic sizes, that still provides ample room for Atx builds. I'm using the reverse feature (glass side on right) so that I can see my stuff. No issues. Stuff this case with seven Lian Li fans plus a 360 aio cooler and you add another $300, but it sure is pretty!

The modularity with the Evo is unbelievable. I’ve had it normally oriented, then switched to inverted orientation. I had my EVGA 3080ti FTW3 vertical, normal, and settled on upright. I have two psu’s in the back. Cable management is so simple, especially with the Lian Li AL fans being daisy chained creating only one simple connection for three to four fans. You can get an extra I/o port if you want and mount it up top or on the bottom of the case. You can replace the front glass panel with a mesh front and add an additional three fans if you want. I managed to fit a push pull setup behind my gpu. It’s just a lot of fun and the inverted and upright gpu orientation is not for laughs, it brought the best temperatures for me throughout. Also, adding the larger pci riser from Lian Li cleaned the case up even more. I plan to throw a liquid cooling loop in it later on.

es un o11 asi que uno ya sabe que esperar en cuanto a calidad. no puedo recomendar este case a alguien que busque costo/beneficio porque requiere 5-7 ventiladores MINIMO para funcionar bien. si no estas dispuesto a hacer ese gasto, mejor busca otro case que sea mas amigable con el bolsillo. pros: * mas que suficiente espacio para un cableado excelente. * comodo para construir. * puerto frontal usb-c 20 gbps. * permite meter enfriadores de aire sin problema (tiene 163mm de espacio). * incluye el soporte anti-sag GB-01 en el paquete. cons: * los opcionales no son nada baratos. * no incluye el accesorio de filtro de aire frontal. * debido a la cantidad de ventiladores y demas cosas que uno puede meterle, construir en este gabinete puede tomar algo de tiempo. * no es muy amigable con hdds o ssds. require que se usen cables sata 100% rectos o hay riesgo de romper alguno de los hdds debido a que la caja para hdds es algo compacta.

slechte functionaliteit

Gostei muito da qualidade do produto, muito espaçoso, várias opções para montagem de setup e bem pesado. O material é de ótima qualidade, tudo muito bem organizado e clean. O gabinete acompanha manual de instruções com todas as informações necessárias para instalação. A entrega foi rápida, chegou antes do prazo estipulado pelo site. Único ponto negativo (no meu caso) foi que ao desembalar para verificar se estava tudo certo com o protudo, reparei um pequeno risco na tampa lateral e um leve amassadinho na "grelha" que só consegue ver se chegar muito próximo. Mas podem comprar sem medo, esse gabinete é um absurdo de qualidade e beleza. OBS: A VERSÃO CINZA DESTE GABINETE POSSUI UMA TONALIDADE MAIS ESCURA DO VIDRO LATERAL E FRONTAL, A VERSÃO BRANCA POSSUI O VIDRO TRANSPARENTE E A VERSÃO NA COR PRETA TEM OS VIDROS COM UM TOM ESCURO, PORÉM, NÃO TANTO IGUAL O CINZA.

La Lian-Li O11 Dynamic Evo si presenta come aggiornamento del già acclamato case O11 Dynamic, portando con sé una serie di miglioramenti sia estetici che funzionali. Questo case è stato progettato con una precisione impeccabile, combinando un design innovativo con una funzionalità ottimizzata per soddisfare le esigenze dei builder più esigenti. Linee pulite e una costruzione robusta, con struttura in alluminio di alta qualità. L'ampio pannello laterale in vetro temperato offre una visione cristallina degli interni del PC. Struttura a doppia camera che permette di nascondere tutti i cavi con ampia comoditá. Hanno pensato a tutto! Offre un'esperienza di assemblaggio senza problemi. I suoi numerosi punti di montaggio per unità di archiviazione, schede madre e altre componenti rendono l'installazione dei componenti un gioco da ragazzi. Inoltre, i pratici passacavi e i vani nascosti per i cavi consentono di mantenere un aspetto pulito e ordinato, migliorando la circolazione dell'aria e riducendo l'ingombro. Con la sua configurazione versatile, questo case supporta una vasta gamma di configurazioni, consentendo di sperimentare con diverse disposizioni e soluzioni di raffreddamento. Grazie alla sua ampia compatibilità con ventole, radiatori e sistemi di raffreddamento liquido, è possibile ottenere prestazioni di raffreddamento ottimali per qualsiasi tipo di build. Se cercate un case che sia tanto bello quanto funzionale, la Lian-Li O11 Dynamic Evo non vi deluderà. Molti altri brand lo stanno copiando, con prezzi inferiori, tuttavia questo rimane il numero uno. Forse la sua modularitá é anche troppa per utenti medi, credo infatti sia piú adatto agli smanettoni a cui piace provare diversi stili di build

Das Lian Li O11 Dynamic EVO ist für mich eines der besten Gehäuse, wenn es um Flexibilität und kreative Freiheit beim PC Bau geht. Die Möglichkeiten zur Individualisierung sind enorm, egal ob Luft oder Wasserkühlung, vertikaler oder horizontaler GPU-Einbau, RGB-Setups oder Silent-Builds: Hier ist fast alles möglich. Besonders hervorheben möchte ich das durchdachte Kabelmanagement. Hinter dem Mainboard-Tray ist mehr als genug Platz, um Kabel sauber zu verlegen, und die zahlreichen Durchführungen sowie Klettverschlüsse erleichtern das Ganze erheblich. Das Ergebnis: ein aufgeräumter, professioneller Look ohne viel Aufwand. Die Verarbeitungsqualität ist tadellos, das Design modern und das modulare Innenleben durchdacht. Auch für größere Builds oder aufwendige Custom-Loops ist ausreichend Platz vorhanden. Kurz gesagt: Wer Spaß am PC-Bau hat und ein Gehäuse sucht, das maximale Freiheit mit cleveren Details verbindet, wird hier garantiert fündig.