Aube Technologies TH115-A-120S 7-Day Programmable Line Voltage Thermostat for Electric Heating

We bought this thermostat because I installed two similar models in our house and they worked wonderfully. I also wanted the thermostats to match. All of our heating is forced air (fan) electric wall units. We have a 110 and 220v heater in our house, and the studio has a 110v. This model installed easily and works perfectly. I don't mind that there is only one "home" temp and one "away" temp. These settings meet our needs. When we leave for a weekend or vacation we simply switch to the "away" mode, which is a 3rd temp, but will hold the temp until you return even if there is a normal schedule change.Works perfectly with our Cadet forced air wall heaters. The 15 minute on/off cycle is ideal for fan-based heaters. Also, the backlight and clean design are a wonderful bonus.We've never had a problem with our other thermostats like this one, and we've had them for years!

We've been installing these on floor heating systems for years. They are cheaper than most other ones and work well. No complaints what so ever. Recommend for any line voltage heating application just make sure you orde correctly for your wiring setup

I'm using this to run a wall panel heater. It was easy to install and works well, but the set-up is a little confusing. You have four times that you can set temperatures for. You can adjust the times and the temperature for each time, but they are on different screens and require a series of steps that isn't very intuitive at first. PSA - make sure to install at least an inch away from any trim, as the right and left hand corners pivot out to reveal the controlling buttons. At first I had this installed too close to a piece of trim and the door wouldn't open sufficiently to push the buttons. For most this probably won't be a problem.

When purchasing a product that I either need or want, I usually always go back to a product that’s both reliable and familiar. Not only is this thermostat digital but it’s both automatic and manual plus easy to install. If you’re a DIYer, all the better. Just a few hand tools and you’re done.

This is a nice device. It’s been in use for some time now. I’ve installed so many similar devices like this that have “rated" contacts. Many burn up over time and need to be replaced. In my opinion, with the cost of these devices, it’s well worth it to use a control circuit and contactor. It’s much cheaper and easier to replace a definite purpose contactor (if, or when it goes bad), than it is to replace and reprogram a thermostat.

Not yet installed, but looks to have great features.

This Thermostat works just as i wanted. Easy to hook-up with supplied directions.I hooked it to my in floor electric heating mats, have it programmed to start warming my tile bathroom floor 2 hrs before i get up and i have it stop when we usually go to bed.This is the same as the honeywell that you buy at home depot, just cost less. Other than the printed name on the unit they are the same.2 flaps on the sides keep all the buttons hidden (and man there are a lot of buttons) so the unit looks sleek and modern.Highly recommend the product.

Very misleading. Too bad my contractor didn’t let me know in time I would have returned it.

Worked great

I used this product to replace an older unit that stopped working. It was easy to figure out how to do it and the manual was helpful. Just review the dip switch settings. They can be a bit confusing but a little research fixed that in no time.

Easy to install, everything worked right away.