Front Suspension Lift Kit - 1.5 inch Lift Height - Compatible with 2007-2021 Toyota Tundra 2WD 4WD and Sequoia (Non Electronic Struts) - Leveling Kit Strut Upper Top Aluminum Spacers Accessories

This spacer installed on my '21 Tundra TRD Sport 4x4 without issue. No cutting of the existing tophat studs required, they get repositioned to sit in the existing coil pocket dimples. Raised the front 1.5" in my case. I have about 3/4" to 1/2" rake to the front now depending on how how I park. No over exersion of sway bar links, ball joints or cv angle.There is a limited market for Tundra spacer level kits less than 2", was glad I found this one. It's a solid kit, uses studs instead of threading bolts into the aluminum (like other kits out there). This is a bargin for the quality and 1.5" is a good level to take out most if the rake and not have to raise the rear too. I'm running on 20x9 +20 wheels and nitto recon grappler 275/55-R20 tires.Get an alignment afterwards to fix everything you moved around during installation.

A levé le devant d’environ 1.5 po. Facile à installer (1.5h)

Advertised as 1.5" however they are only 1". Already installed before I realized this. So disappointed.

Perfect spacer lift to raise the front of my Tundra. Added this and a 1” shackle lift to the back and it looks perfect. Extreme quality spacers and no need to spend what some of the competitors are charging when it is just as good, if not better.Update: These spacers level the truck perfectly, however, I decided I wanted just a little rake added back in, so I added a 1” Toytec aluminum block to the rear suspension and it came out with the perfect stance for me.

Liked the product. Shorter than the 2" thus easier on ball joints. You will need an alignment after install. Not a hard install but if you have a lift it will be much easier. I did it with no lift and alone. Took about 2-3 hours each. If you don't have new ball joints go ahead and replace them too...