4Pcs 1:10 RC Car Drive Shaft Front and Rear Universal Drive Shaft CVD Heavy Duty Compatible with 1/10 Traxxas Slash Rustler VXL 4X4 4WD Replacement Parts (Red)

Did not think changing out the drive shafts would make a large difference but for some reason this car now moves like greased lightning. If you get these you would do well to put a small dot of loctite on the set screws because the drive shafts spin so hard after a few rounds on the track they spin loose and fly out lol. 🤙

Put them on my Rustler 4x4 vxl they lasted 5 minutes before blowing apart at the pivot. Don’t waste your money on these.

I read alot of bad reviews about these and alot about how they would not fit the 1/10 rustler vxl 4x4. I honestly think it might be becuase I bought after market hub carriers but I also doubt it as well. These things so far have done AMAZING. ABSOLUTELY not fitment issues and I think it might jsut be the installer or they changed it.. again no offense.. might be due to me having after market hub carriers. I absolutely tore up my back yard, my street and jumped it and no issues. Only thing I recommend is if the manufacturer or dealer could supply more Allen screws for the joint to the diff. Even after about a 30 minite run hard as heck I mad sure to take it in and do a re check om tightness.. I was missing one on the front right diff connection, which might affect me hear soon.. I recommend using something as locktight to keep em in. Nothing permanent ofcourse to impede your ability for removal but, again, to the dealer.m please supply more screws. So far so good I will do a follow up if needed.

Great upgrade. Insulation was easy and quick. What a difference! Rolls smoother and less resistance. Hoss should actually run faster because it feels less resistance. Looking forward to test it this weekend

Set screws don't hold to much play at different shaft. The sleeves suffer from same issue to much play. I've used spacers washers and all at the hubs and never got them to sit correctly without having a rattle. Would not recommend these at all. They are certainly metal, have nice pivot angles, and the spring retainers for the pins are a great idea. But machine tolerance quality is severely lacking.

I bought these as an upgrade for my Slash 4x4 after snapping a factory plastic one. You have to press the drive nuts onto the shafts. They do not go very easy and once they are on, good luck trying to remove them. I had to use a vice and prybar to remove them.I got into one accident and the axle end bent. $40 down the drain as its now useless. Buy a differnet brand

These worked alright for a while, but they are not great. For starters they do not fit very well on the Traxxas slash 4x4 like they say they are for. They leave a lot of play in the wheel causing a lot of wobble. Another issue is that they rely on a little pin to stay assembled that is only kept in by a metal ring around the outside. This design fails VERY easily and resulted in it popping off mid drive, and now I have to purchase new ones. Will definitely be staying away from these and any similar designs from now on.

The shaft is to short causing the wheel nut to loosen every ten minutes of run time

Does not fit as described..... Not even close ! Trash waste of money. Chinese garbage

Got 15 minutes out of it and then put back a stock AK and the next one broke in about 15 minutes I threw them in the garbage