Hight Quality 60A Drum Switch Forward/Off/Reverse Motor Control RainProof Reversing

This product arrived in a timely manner and had no damage. I was able to easily use it for what I needed. I used this to reverse the motor on a gas tank rotator I made. 10/10

Pretty easy to install there's not a ton of room inside the switch box but I was able to get it to work, replaced an electronic switch that stopped working once it went under water. I think because there's no electronics in this drum switch it should be better in case it goes under water.

It works perfectly. Great deal at this price. I think a lot of negative reviews happen because wiring can be tricky and it's easier to blame the switch than your own mistakes. This really is a good switch.

120 v, reversing motor for latheThe first problem is The directions all in Chinese. Attached is a translation. Second is that there is not enough room for #10 wire, forget about wiring for 60 amps. I had to crisscross the wires over the drum to get them to fit, not the best way. And the little grommets are a joke. For proper wiring, you need cable clamps but it is still a very tight fit.Once wired, the switch works fine

Seller describes this switch as applicable for a 120V motor. This is not possible with this switch. This appears to be a 3 phase switch; not a 1 phase switch. If you your motor is 1 phase, don't buy it!

The switch may come to you with not all the switches functioning. Don't be afraid to to remove the drum switch from the j-box. You will find windows on the side of the switch body for all 5 contacts. Use a meter and check for contenuity at each switch that looks closed. Do this in forward and reverse. Mine had 2 contacts that looked closed and were not. Use a screw driver or needle nose pliers to adjust the copper strips that holds the contacts. A new switch from Jet would have run me over $110, this fix cost less than $20. Most of the work is in mounting the new j-box. Fixing stuff is why we have tools. I'm I right?

I have a single phase motor on my lathe machine with four wires and once I figured out the wiring pattern this switch works both forward and reverse with no problems yes I tripped the breaker a few times but that's my fault for not searching up the correct wiring 😁

Works well!