Inner Cam Bearing Installer & Puller, Compatible with Harley Davidson TC 88 96 103 110

Pulling the bearings was fine, had there been some damage or problems, it may not have worked so well. Pressing in the new bearing however was a problem. While pressing them in, about 1/2 - 2/3 of the way in, the end of the tool spread out over the press anvil. Tried the second one, with the same result after finishing the first bearing, it spread on the second. squeezed it together and placed a hose clamp on it to finish the job. Ordering a replacement tool instead of a refund, as I now have some steps I can take to prevent damage in the future. Shouldn't have to, but it is a simple fix and the price is fair.

I ordered the bearing tool but it didn't line up with the holes and returned item. 5 stars because they do stand behind their product and give a no questions return.

Very cheaply made and not worth the money. Spend the extra cash and buy the real thing. You might spend more but you’ll be better off to have a tool you can use.

Worked for my cam swap. I didn’t have alignment issues like other reviews but I can see where the problem would be. Easy fix to drill the hole a little larger for the dowl pin to line up. Had to zip tie the press screw end for bearing install because it would spread open. Would not recommend this for shop or daily use. But for the price it’s good for one time use.

Holes were not properly laid out. Nothing actually lined up properly. Keep your money and shop with a quality tool maker. $100 isn’t worth lunging a 1.5k or more engine over. Just do the job right please don’t regret not buying the right tool months later when you have a inner cam bearing problem.

It’s ok, works but the pullers are cheap, I would look for a better one

Tool is a piece of junk.The two main threaded holes that you use to pull and install the bearings, where not square with the plate.The plate did not even fit right on the block.

Had to mod it to make it work