Flashers #3 Grey EPDM Flexible Roof Jack Pipe Boot Metal Roofing Pipe Flashing (Pipe OD 1/4" to 5") - 100% Made in The USA

Came in good condition and now it's on my roof.

Small and inexpensive. It works

easy to install, seals well, but holds water in bottom fold

Did the job

Using these to transition my cooling/ electric lines thru wall for Mini-split application. Durable, quality item at a good price.

replaced existing sun damaged piece

I had an electric power inlet pipe on my roof that I could not slip over a normal pipe boot so I purchased the cheapest pipe boot available because I had to cut one side of it to make it work. Before installation, I installed waterproof roofing membrane and chalk the pipe to the waterproof membrane. I then cut and install some aluminum flashing with 1/4 inch or less clearance to the pipe and chalk the aluminum to the roof surface and the pipe. Finally I used this product after cutting one side and chalk the base to the roof surface and chalk the cut opening that I made. With three separate barriers of protection, this should work. I do not recommend using this product as your only barrier of protection. Cutting the opening to this product was easy. However, cutting the correct size pipe opening was not easy: you have to cut the circle by hand so the pipe opening was not a perfect circle. I had to take away 1/2 star for this. I undercut the circle diameter to make sure the fitting to the pipe was tight.

Good price too