Jellas22PCS Damaged Screw Extractor, Screw Remover with 64-65 HRC Hardness, Separate Burnishing and Magnetic Extension Bit Holder for Damaged Screws or Bolts 2-12mm SE22

Was nervous using this as I had to remove 3 small m2 screws from my computer laptop motherboard. But it worked. Got them out fixed my board. Got my laptop working again.

Doing DIY on the car drunk 🥴, I managed to round off a star drive screw. Tried to fix it with a hammer 🔨 and screwdriver to only make matters worse 🙃.Purchased this kit, instructions was clear use correct drill size first then change to extraction bit, one squeeze of the trigger and out it came, saved me a fortune in a garage bill. No reason this wouldn't work for security screws the lot even if they are in solid

Rounded off a screw on my Dyson V11 battery. After trying every way YouTube advised with no joy, I opted to purchase the screw extraction set, and it worked a treat! Not sure how they would hold up against very tough screws in wood/metal but, for smaller screws in electrical equipment they are very effective. If you've tried other methods and had no luck, definitely give these a go.5 star product for my personal use. Given 4 stars as the carry case arrived badly scratched up.

Bought this kit to extract a broken off screw from an Espresso Machine portafilter handle holder. Have a lot of experience with tools and DIY. Smallest drill bit broken off at first attempt. We then proceeded with the largest bit that could fit into the broken screw without risking to damage the actual Portafilter. The drilling went ok and the extractor bit went in as expected. The battery drill clutch though was preventing extraction so we attempted to use and hand driver, and guess what, the extraction bit snapped, right off, looking very brittle, but then, nothing now seems to drill into it, no other drill head from the same kit, not high quality metal drilling bits. Searching my problem I found out that it happens often with low quality extraction kit, and the solution is either a specific tool costing £98 or a carbide drill bit at the cost of £20-30 per size. My recommendation (and what I would have done if I had the chance again) would be to simply drill the screw with a standard metal drill bit and use a Threading Tap to re-thread the hole if needed. I have to know buy a brand new Portafilter at the cost of £50 because of the damage caused by this extraction tool.

they do work but 2 of them broke, to easily!

I really needed one of these sets. It is easy to use if you follow the detailed instructions. The bits are made well and are durable too. I like how they come in a nice case all labelled up too. I like the handy guide of extractor sizes compared to what screw size you are using. No more half screwed in screws for me.

I purchased these to remove an anti tamper screw on a Kral Puncher Maxi which was a little hot on the power side, this screw extractor kit made the job easy and fuss free. I expect it to be good on smaller screws but i doubt it'll be strong enough to remove decking screws etc.It did what I needed it to no problem though.

I was hopeful this toolset would help, however it didnt - I am unable to confidently blame the tool as I think it is equally possible I just did not or could not use it properly.