Espen LED Driver VEL12053120HDA-3 TRIAC Dimming, Constant Current, Max. 12W, 530mA, 120V input Operating Voltage Range 16-21V

Fixed the light good as new

I have a large number of LED ceiling lights that I put in a number of years ago, and are no longer available in the exact same style, so as they start having problems, I have to replace the drivers in them, otherwise I have mismatched lights if I just replace the whole light. That would drive my OCD crazy. These work fine, while not being absolute exact replacements.

Easily installed the LED ballast and it has been working for 6 months without issue.

My 4" LED pot lights are in IC rated housings in my kitchen ceiling. Two of the six lights have failed over the years and it is not possible to change the whole light without considerable expense (unless I go for different style lights in various locations since the original lights are no longer available). Replacing the power supply is much cheaper and much easier. These work very well.

This driver works better than the last one I bought. However, it also does not stay on and seems to flicker. I think this is a result of the dimmer switch that is being used which is a mechanical dimmer.

Works great. I broke the small connector on the actual led panel installing it. If I had to do it again I would have spliced the small black and red wires (not the load, or bigger white and black wires).

Exelente

One of our hi-hats lights stopped working so instead of replacing the whole hi-hat we just replaced the part which was less expensive.