Parking Assist System with Rear View Display, 4 Drill-in/White Backup Sensors (SD4-T)

Descripción

The system will beep based on the distance of an object behind the car. The display left and right bars show the distance of the object behind the car. The device is only activated when the driver puts their vehicle into reverse. Four ultrasonic sensors mount on your bumper. A drill bit for the size of the sensor is included. Installation Step 1: Connect the Electric Power *Open the trunk, find the wires to the back light housing. *Use of a 12 volt multi-meter, Probe the appropriate wiring harness which heads toward the reverse light connector of the vehicle, looking for the wire which carries +12 volts when reverse gear is engaged, and no voltage when reverse gear is disengaged. Step 2: Install the Backup Sensors in the bumper *Drill four holes in the bumper via provided drilling bit. *Install the insert-style sensors in the bumper.*Run the wires of sensors into the trunk, and plug in the control center.*Connect the power line of control center with the power line of backup light