30ft PET Expandable Sleeving Wire Cable Sleeve (1/2", Black)

Exactly what I needed. Super easy to use, makes cable management so much cleaner

These add a little appeal and help protect wires from rubbing and heat.I did read reviews before purchasing and you do indeed have to gently push ends towards one another to create slack in sleeve once it's on you can easily pull the slack back out by pulling it tight

As expected

I ordered this to put 3 - 20’ 1/4” guitar instrument cables in that run from my pedal board to my amp. It was very tight, and my wife helped me to get them in, but the end result looks great! I like the black and silver design, plus it doesn’t “feel” cheap.After I got what I needed, I cut off the excess and burned the ends with a lighter. I also ordered some heat shrink tubing to put on the ends where the sleeve and cables meet (I would highly recommend doing so).Be careful when using a heat gun close to it, as it burns very easily. After cutting off the excess, it will fray very easily and quickly if you don’t burn the ends.

Nice for detailing my wiring.

This is exactly as described i love the blue/ yellow colors too.

Works as intended

I used the 1/2" (Silver and Black) on my RCA cables for my car audio install (with white heat shrink to hold the ends). It's a snug fit to wiggle both RCA ends into the cable and start snaking it down the cable, but the fit is pretty good once it's all pulled through and snug, with heat shrink holding the ends.It will frey quickly if you don't melt the ends after snipping them.I used the 1" for my 0 gauge and 4 gauge power wires (Red / Black with red heat shrink for positive & Blue / Black with black heat shrink for the grounds). 1" is way too big for the 4 gauge, but I didn't want to order more just to make it fit better.I'm using the 3/8" for my (14 gauge and 16 gauge) speaker wires (Silver / Black) but I haven't worked on that part of my installation yet.This stuff is great to disguise same color wires. I have a roll of red 0 gauge wire and a lot of different colored 4 gauge wire, so I wrap it in this stuff to designate pos/neg, and you can't tell once it is all wrapped up. It also makes some of my cheaper looking RCA cords look very nice after they've been covered.