Acrylic Panel and Case Joystick DIY Set Kits Replacement for Arcade Game Machine Cabinet Controller DIY Kit

Its made better then expected and really like this case the suction cups work extremely well my only negative thing is it collects fingerprints way to easily but easily solved with a graphics decal definitely planning on getting another one. Great buy

It's cheap, and it's solidly built. Can't really complain. The three top holes are not 30 mm but rather 24 mm. If you don't have 24 mm buttons, you'll have to make some modifications. I used a 1 1/8th Forstner bit and increased the hole sizes to accommodate 30 mm buttons. Additionally, the text and outline around the Start button hole flake right off. So, if that matters to you, be warned it's not going to remain.

I had built a cabinet and it became hard to move and work with... These replaced that and I just need to connect the two controllers to the RetroPie I was using before... it is not the same but it was a great approach to keeping everything neat without sacrificing the arcade experience.

Durable and the price is right. Plenty of room inside for customization.

Back a few years ago, these off-brand plastic housings were adequate, and more importantly, they came with the requisite hardware to assemble properly. The quality has taken a HUGE hit and quite frankly, this is garbage. It doesn't come with proper screws to mount the top to the base. For some reason they do not fit through the base holes. The holes seem smaller in the plastic base than the top and the screws are not self-tapping, so the diameter is important.Something to keep in mind when ordering these types of cases. If I had more skill i suppose I could make my own, but these do save time, provided you get the right hardware. :)

I have two of these models, the one shown here with the three smaller buttons and the other six button configuration.I used micro switches with are too tall for this case. But I did find a solution that worked, by using a nut on the top side of the button, it gives the extra clearance needed to close up the case.This will require a 2nd set of buttons -SJ@JX 10 PCS Arcade Game Push Buttons with Microswitch Logo X Y Start Select for PC MAME Raspberry Pi Blue https://www.amazon.com/dp/B07X3K5N3R/ref=cm_sw_r_cp_api_i_ZU36EbVBSX1M0Unless you can find the nuts sold by themselves.Overall- it would be awesome for this company to just make a deeper case or alternatively- you can make a wooden box and just use the acrylic top.

Great little project box. Saved me a significant amount of time. Built a Dreamcast arcade fighting joystick. Plenty of room in the boy for the controller and the rumble pack.

Only 2 annoyances. 1st is that the main holes are 30mm while most button kits appear to be 28mm (at least the ones I found and purchased). This was a small deal that was easily remedied with a few 1mm width 30mm diameter rubber o-rings. 2nd bigger annoyance is the difficulty in finding 24mm buttons for the 3 top holes. I had to buy a large drillbit to drill the Start hole wider to use with my kit, and I currently have 2 unused 24mm button holes. Other than this, kit is great.