Cold SteelQuiver Guard

It does its job. Fits tight. Etc.It fit my 2 piece tim wells stock master.It is only a 1 pack. Which is disappointing. I was expecting a 2 pack like the other quiver pieces you buy. But it's ok I guess.

This FITS my Cold Steel 5ft Two Piece Blow Gun Perfectly and FITS the other .625 cal standard models... WILL NOT FIT the 4ft professional model

FOR STANDARD MODEL ONLY (too small for professional model)

Really like having the extra protection. Slightly loose on my big bore, but a wrap of duct tape helps.

For what it is I thought it was a little over priced.

The 625 Quiva guards do not fit. I have tried several ways to put them on. With no success. I am a person that despise sending stuff back. It takes too much time out of my day to go to the post office, a whole food on the other side of town. I am highly disappointed. I read the display in article several times to convince myself I did not miss read it. Plain and simple rip off.

I use two of these on each side fo the quiver to keep from snagging the pointy darts I have placed in alternating directions.

I have a Cold Steel Magnum Blowgun and this didn't fit. I used my caliper to measure, the OD of my blowgun is .866, the ID of this is .743. I know .123 inches isn't much, but it's enough to make sure this didn't fit. I have 2 starts, because of it did fit, it looks well made. The markings are exactly like the 2 I currently have on the blowgun.